ProSim737 version 2.07

Announcements by the ProSim-AR team
User avatar
Posts: 124
Joined: 01 Aug 2016, 16:47

ProSim737 version 2.07

Post by martin.vsetecka » 19 Jul 2018, 20:34

July 19 2018 Release version 2.07
- New 8.33Khz voice channel spacing
- Added voice channel spacing option
Note: Hardware handling the frequency change internally does not support 833 unless implemented internally.
The 833 option can be enabled on IOS -> Cockpit Setup -> Options
It requires FSUIPC 5.132b (P3D V4 only) if using MSFS option
- Improved A/T RETARD mode (A/T will reduce thrust at a lower rate to avoid initial steep descend)
- Improved A/T response when speed is below commanded speed
- Fixed small issue causing ProSimMCP crashing when not connected to the simulator
- Added option to revert EFIS MINS mode on Sismo driver (for older models)
- Improved ALT ACQ transition to ALT HOLD
- Fixed SPEED mode not engaging if LEVEL CHANGE is active
- Fixed A/T mode in ARM when ALT ACQ is active
- Added scavenge fuel pump
- Signs refactored
- Small fix to prevent ProSim crash when FSUIPC address is 0x0000
- Added backlight control and dim/bright control to Poldragonet overhead driver
- Fixed N1 reduced rates not resetting after landing
- Improvements to poldragonet driver
- Reworked SIOC Direct port options
- Added STANDBY POWER gate
- Added support to use USB Expansion and USB Outputs as GATES
- Added option to enable Tiller input when using CPFlight Driver
Martin Vsetecka
ProSim Support


Return to “ProSim737 announcements”